Wildcat Sandblast Hose, 2.36 Inch OD, 1.50 Inch ID, Up To 100.00 PSI

Absolutely, this Wildcat sandblast hose is designed for conveying sand or shot for cleaning. It's also good for moving sand from sandblast equipment, like when you're cleaning steel or concrete before painting. Just make sure to check your specific application needs against the hose's limitations.

The inside diameter is 1.50 inch and the outside diameter is 2.36 inch, so you can match it to your 1-1/2 inch I.D. requirement and still plan for the bulk on the outside.

Rated from negative 40 degrees F up to 158 degrees F, so cold weather shouldn't be a problem for most working conditions. The natural rubber tube and SBR cover hold up well across that range without getting brittle or stiff in low temps.

Rated up to 100 PSI, so it holds its own for most sandblasting setups you'd run into on a jobsite or in a shop. That pressure ceiling is right in line with what a standard blast pot pushes out, so you shouldn't have any trouble there as long as your system stays within that range.

This Wildcat sandblast hose is rated for up to 100 PSI.