Skip to the beginning of the images gallery

Wet Exhaust 90° Elbow, Molded HT EPDM 250°F, 2.00 Inch ID, Inch Clampable OD

Angle 90°	Construction Molded HT EPDM 250°F	Brand Trident Rubber LLC	Brand Trident Rubber	Pack Size 1.00	UOM EA	Hose I.D. 2	Includes Clamps	Minimum Clampable Length 1.75	Supplier Part Number TRL-290-S/S	Temp. Rating 250	Alternate Part Numbers Alternate Part Number C1FV18, Alternate Part Number TRL-290-S/S	Product Weight 1.29 lbs

Product Questions & Answers 2

Product Questions & Answers

got a 2 inch wet exhaust run and need to make a tight 90 without fighting it, is this the right elbow?

Question by: Diane B on Jun 8, 2025, 10:01 AM

For a marine wet exhaust setup, it’s a molded 90 degree elbow with a 2.00 inch inside diameter and a smooth interior to help keep back pressure down. The heavy wall EPDM is made to handle misalignment, movement, and vibration that you get around an engine.

Answer by: Customer Support on Jun 10, 2025, 6:05 AM

What’s the heat tolerance on this elbow?

Question by: Howard C on Oct 15, 2025, 11:18 AM

It’s made from a high-temp EPDM rubber that can handle up to 250 degrees Fahrenheit.

Answer by: Customer Support on Oct 16, 2025, 8:44 PM

Similar Products

Model Number	Hose I.D.	Angle	Construction	Minimum Clampable Length	Includes	Temp. Rating
290V3000SS	3	90°	Molded VHT Blue Silicone 350°F	1.5	Clamps	350
TRL290SS	2	90°	Molded HT EPDM 250°F	1.75	Clamps	250
TRL345SS	3	45°	Molded HT EPDM 250°F	1.5	Clamps	250
TRL3590SS	3.5	90°	Molded HT EPDM 250°F	1.5	Clamps	250
TRL390SS	3	90°	Molded HT EPDM 250°F	1.5	Clamps	250
TRL490SS	4	90°	Molded HT EPDM 250°F	1.5	Clamps	250
TRL545SS	5	45°	Molded HT EPDM 250°F	1.62	Clamps	250