Wet Exhaust 90° Elbow, Molded VHT Blue Silicone 350°F, 3.00 Inch ID, Inch Clampable OD

It is a molded 90 degree elbow with a 3.00 inch hose ID. Clamps are included, and you will want at least 1.5 inches of straight length available at each end for clamping.

Clamps come with it. Each end needs a minimum of two stainless steel clamps at least half an inch wide, and the hardware is already bundled in. For best results, Trident recommends 3/4 inch wide T-Bolt clamps or 5/8 inch wide Constant Torque clamps, so what's included should get you set up without a separate order.

This molded silicone elbow is good for continuous use up to 350°F.