Steel Adapter, 3/4-16 Female JIC 37 deg Flare Swivel To 3/4-16 Male JIC 37 deg Flare, Long 90 deg Bent Tube (For pressures thru 4 Light Spiral Hose)

You'll find these adapters used a lot in marine and military applications, but also in chemical processing, pulp and paper plants, and even food and beverage production. They're also suitable for off-shore drilling rigs.

For tight routing, it’s a long 90 degree bent tube adapter with a 3/4-16 female JIC 37 degree flare swivel on one end and a 3/4-16 male JIC 37 degree flare on the other.

For light spiral hose applications running through 4 Light Spiral pressure ratings, yes, that's exactly what this adapter is sized for. Both ends are 3/4-16 JIC 37 degree flare, so as long as your existing line uses that thread size on each side, the fit should be straightforward. The swivel on the female end also makes it easier to thread in without twisting up the hose during assembly.

This Eaton Aeroquip adapter is suitable for chemical processing applications, among others.

For pressures running through 4 Light Spiral Hose, yes, this is the correct adapter. It's a long 90-degree bent tube elbow with a 3/4-16 female JIC 37-degree flare swivel on one end and a 3/4-16 male JIC 37-degree flare on the other. The swivel end gives you a little wiggle room during installation so you're not fighting the hose to get alignment right. Eaton Aeroquip makes this one, catalog number C1BS36, so it's a known-quantity part rather than a no-name fitting.

Built as a long 90 degree bent tube elbow, it goes from a 3/4-16 female JIC 37 degree flare swivel to a 3/4-16 male JIC 37 degree flare. The swivel is on the female flare end.