Got a tee fitting that needs replacing on a pipe run, and the existing setup is all 1/4 NPT. This one got both a female run and a male branch on it?
Question by: Peggy M on Feb 15, 2026, 5:20 PM
Yeah, that's exactly what this fitting does. The run ports are 1/4-18 female NPT, and the branch comes off as 1/4-18 male NPT. So if you're tapping into an existing pipe run and need that male branch coming off the side, this is the right configuration for it. All three thread sizes are the same, 1/4-18, so no reducers or adapters needed if your existing lines match that size.
Answer by: Customer Support on Feb 16, 2026, 5:59 PM
What's the overall length of this tee fitting? Gotta make sure it'll squeeze in where I need it.
Question by: Shawn R on Feb 28, 2026, 12:08 PM
It's right at 1.76 inches long. Should be pretty compact for tight spots.
Answer by: Customer Support on Mar 2, 2026, 7:59 AM
got a tight spot on a hydraulic line, how long is this tee fitting end to end?
Question by: Steve F on Mar 26, 2026, 9:20 PM
At 1.76 inches long, it stays pretty compact, which helps when you are trying to add a tee connection in a cramped area.
Answer by: Customer Support on Mar 28, 2026, 6:37 AM
