Stainless Steel Duolok Tube Fitting, 0.25 Inch Tube OD Union 90 deg Elbow

For 1/4 inch OD tubing, yes, this is the right fitting. It's a union 90 degree elbow, so both ends accept 1/4 inch tube and it makes a full direction change between them. The double ferrule design seats against the tube wall on both ends and compensates for minor differences in wall thickness or tubing hardness, so you get a leak-tight connection on each side. Good fit for panel or bulkhead routing where you need a clean 90 without a lot of fabricated bends in the line.

Built for 0.25 inch tube OD, this union 90 degree elbow is meant for instrumentation and process tubing setups using stainless steel tubing. It uses a double ferrule design that helps take up small differences in tube wall thickness and hardness so you can still get a solid seal.