S Series Geroler Motor, 3.60 cu in/rev, 2 Bolt Mounting Flange, 1 in. Straight Keyed Shaft, 7/8-14 St.Thd. O-Ring Ports, Compact yet powerful|Extended bearing life|Increased shaft seal

For best motor life, run it about one hour at roughly 30 percent of rated pressure before you put it to full load. Make sure the motor is filled with hydraulic fluid before you apply any load.

Rated at 115 newton meters, this motor has enough torque for continuous auger duty. For best long-term results, Eaton Char-Lynn recommends a break-in period of about one hour at 30% of rated pressure before you put it under full load. Make sure the motor is filled with fluid before any load is applied. Running it that way from the start helps protect the internals and extends service life considerably.