S Series Geroler Motor, 22.70 cu in/rev, 2 Bolt Mounting Flange, 1 in. Straight Keyed Shaft, 7/8-14 St.Thd. O-Ring Ports, Compact yet powerful|Extended bearing life|Increased shaft seal

Make sure to fill the motor completely with premium anti-wear hydraulic fluid before applying any load. To ensure the best lifespan, you should also run it for about an hour at 30 percent of its rated pressure before putting it to work at full capacity.

For agricultural augers and harvesters, that displacement is right in the wheelhouse. The 22.70 cu in/rev puts out 528 newton metres of torque, which gives you the grunt needed for those kinds of continuous-load applications. Just make sure you run it in proper before putting it under full stress, about an hour at 30% of rated pressure does the trick, and the motor needs to be filled with fluid before any load goes on it.

Port setup on this motor is 7/8-14 straight thread SAE O-ring ports (.875-14 UNF-2B), so it matches the 7/8-14 O-ring style connection.