S Series Geroler Motor, 13.70 cu in/rev, 2 Bolt Mounting Flange, 1 in. Straight Keyed Shaft, 7/8-14 St.Thd. O-Ring Ports, Compact yet powerful|Extended bearing life|Increased shaft seal

At 13.7 cu in/rev displacement and a 1-inch straight keyed shaft with a 2-bolt mounting flange, this motor lines up well for auger drive replacements in that displacement range. The 7/8-14 straight thread O-ring ports are a common configuration on agricultural equipment, so hydraulic connections connections tend to be straightforward on most setups. Before you put it under load, fill it with fluid first and run it easy for about an hour at roughly 30% of rated pressure. That break-in step makes a real difference in long-term wear, especially on a working piece of harvest equipment.

Designed for agricultural applications like seeders and harvesters, this motor is built to withstand demanding use. It's recommended to run it at 30% of rated pressure for the first hour to break it in properly.

The key identifiers on the 103-1038 are a 2 bolt mounting flange, a 1 in straight keyed shaft, and 7/8-14 straight thread SAE O-ring ports (.875-14 UNF-2B). It is also a 13.70 cu in/rev displacement S Series geroler motor.