Polyethylene Tubing, 0.25 OD, 0.04 Thick, 0.17 ID, Up To 200.00 PSI

Yes, this tubing complies with FDA regulation 21 CFR 177.1520(c) for food contact applications, so it should work fine for that.

FDA compliance here is the real deal, not just a label. The resin meets 21 CFR 177.1520(c) and also carries NSF51 certification, both of which are recognized standards for food contact applications. The linear low-density polyethylene used in this tubing was specifically chosen for its resistance to environmental stress cracking, which matters in food processing setups where fittings, vibration, and chemical exposure can wear tubing down fast. Rated to 150 degrees F on the high end and 200 PSI operating pressure, it handles general low-pressure food processing runs without issue.

For food contact work, this linear low density polyethylene tubing is a solid fit since it complies with FDA 21 CFR 177.1520(c) and also lists NSF51 compliance. It’s commonly used for instrumentation and food processing in low pressure, low temperature setups.