got a cylinder that takes a 2.50 OD wear ring, is this one the right size if i need 3/8 wide and 1/8 thick?
Question by: Brett P on May 17, 2025, 1:43 PM
Fit comes down to the three dimensions. This nylon wear ring is 2.50 inch OD, 3/8 inch width, and 1/8 inch thickness, so it matches those size callouts.
Answer by: Customer Support on May 19, 2025, 6:20 AM
What's the operating temperature range on these wear rings? I need something that can handle a pretty wide swing.
Question by: Ray G on Apr 6, 2025, 7:30 AM
The nylon material is rated for use between -40°F and 250°F.
Answer by: Customer Support on Apr 7, 2025, 12:04 PM
what's the temp range on this wear ring? got equipment running in some pretty cold conditions and want to make sure it holds up
Question by: Howard M on Apr 1, 2025, 1:51 PM
Rated from -40°F up to 250°F, so cold weather operation is well within its range. The nylon construction handles both low and high ends of that spread without getting brittle or breaking down under normal hydraulic cylinder loads.
Answer by: Customer Support on Apr 3, 2025, 7:15 AM
Reckon this wear ring would hold up in a system that hits 3000 PSI every now and then, even though it's rated for 35,000 compressive strength? Just want to be sure.
Question by: Harvey P on Aug 6, 2025, 11:10 AM
While the nylon material boasts a compressive strength of 35,000 PSI, it's crucial to consider the application's continuous operating pressure and potential spikes; exceeding recommended limits can accelerate wear and compromise performance over time.
Answer by: Customer Support on Aug 7, 2025, 4:20 PM
got a cylinder that takes a 2.50" wear ring, is this one actually 2.5 OD and what are the other sizes on it?
Question by: Brenda H on Apr 12, 2025, 11:50 AM
The key dimensions on this nylon wear ring are a 2.50 inch outside diameter, 3/8 inch width, and 1/8 inch thickness.
Answer by: Customer Support on Apr 14, 2025, 6:38 AM
