J Series Geroler Motor, 1.93 cu in/rev, 5 Bolt 1/4-28UNF Mounting Flange, 5/8 in. Straight Keyed Shaft, 9/16-18 St.Thd. O-Ring End Ports Ports, Compact yet powerful|Extended bearing life|Increased shaft seal

For continuous back pressure over 1100 PSI, an external case drain line is required. You will need to install that drain line so the motor case stays completely full of fluid at all times to prevent internal damage.

Mounting is the 5 bolt pattern with 1/4-28 UNF threaded holes, so it matches equipment that calls for a 5 bolt 1/4-28UNF mounting flange.

This J Series motor is indeed suitable for food processing applications, among others like agricultural augers and marine bow thrusters.

For best life, run it about one hour at roughly 30 percent of rated pressure before you put it under full load. Make sure the motor case is filled with hydraulic fluid before you apply any load.

Without a case drain, you're good up to 1100 PSI continuous back pressure. Once you push past that, you'll want to run an external case drain line, and when you do, make sure the line is set up so the motor case stays full of fluid at all times. Running it dry even briefly can cause premature wear on the internals.