Skip to the beginning of the images gallery

Hose Protective Fire Sleeve, 2.88 Inch ID

Accessories Clamp (2 Required Per Hose Assembly): FF9217-0664S	Battery Included No	Brand Danfoss Power Solutions (II LLC Aeroquip)	Brand Aeroquip	Pack Size 12.00	UOM FT	I.D. 2.88 in	Machine Mountable No	Minimum Working Temperature -65	Supplier Part Number 624-46	Product Weight 5.51 lbs	Alternate Part Numbers Alternate Part Number C1MZ69

Product Questions & Answers 4

Product Questions & Answers

got a hose that measures right at 2.88 on the inside. is that the ID this sleeve is sized for?

Question by: Phil W on Jun 30, 2025, 4:27 PM

For sizing, the 2.88 inch ID is the inside diameter of the firesleeve itself, so it is meant to slip over a hose or coil where that sleeve ID is the fit you are after.

Answer by: Customer Support on Jul 2, 2025, 7:39 AM

fiberglass sleeve with silicone on it, does that mean it'll hold up if a hose runs right next to an exhaust manifold or open flame situation?

Question by: Lance G on Jun 17, 2025, 10:25 AM

Direct flame contact is exactly what this sleeve is built for. The braided fiberglass tubing is impregnated with flame resistant silicone rubber, so it acts as a barrier between the hose and the heat source rather than just slowing things down. It won't catch or sustain a flame, which matters a lot when you've got hydraulic lines running anywhere near ignition risk.

Answer by: Customer Support on Jun 18, 2025, 12:17 PM

Reckon this fire sleeve will hold up if it's right next to a hot engine manifold?

Question by: Dwight W on Jun 24, 2025, 4:04 PM

This hose fire sleeve is made to handle high heat, with a silicone rubber coating over braided fiberglass. It's rated for a minimum working temperature of -65 degrees Fahrenheit, so it should offer good protection near an engine manifold, but make sure you use the right clamps for a secure fit.

Answer by: Customer Support on Jun 26, 2025, 6:33 AM

got a 2.88 id sleeve here, what’s it actually made of and what’s it for?

Question by: Judy C on Sep 13, 2025, 5:23 PM

Built for hose protection in flame exposure, it uses a single layer of braided fiberglass tubing that is impregnated with flame resistant silicone rubber to help shield the hose from direct flame.

Answer by: Customer Support on Sep 15, 2025, 12:49 PM

Similar Products

Model Number	Accessories	I.D.
624-24	Clamp (2 Required Per Hose Assembly): FF9217-0648S	1.5 in
624-38	Clamp (2 Required Per Hose Assembly): FF9217-0648S	2.38 in
624-46	Clamp (2 Required Per Hose Assembly): FF9217-0664S	2.88 in
624-13	Clamp (2 Required Per Hose Assembly): FF9217-0622S	0.81 in
624-14	Clamp (2 Required Per Hose Assembly): FF9217-0622S	0.88 in