Skip to the beginning of the images gallery

Hose Protective Fire Sleeve, 2.38 Inch ID

Accessories Clamp (2 Required Per Hose Assembly): FF9217-0648S	Battery Included No	Brand Danfoss Power Solutions (II LLC Aeroquip)	Brand Aeroquip	Pack Size 12.00	UOM FT	I.D. 2.38 in	Machine Mountable No	Minimum Working Temperature -65	Supplier Part Number 624-38	Product Weight 3.31 lbs	Alternate Part Numbers Alternate Part Number C1HJ66

Product Questions & Answers 4

Product Questions & Answers

firesleeve got a 2.38 inch ID, does that mean it fits snug over a standard hose or is there some play to it once its on?

Question by: Eddie W on Sep 5, 2025, 6:45 PM

For a proper fit, the 2.38 inch ID is meant to slide over the hose assembly with enough room to account for the hose outer diameter plus any fittings or slight irregularities along the run. You'll want to confirm your hose OD falls within that range before ordering. Two clamps per hose assembly are required to secure it in place, so the sleeve does rely on those clamps rather than a friction-only fit. The clamp part number for this application is FF9217-0648S if you need to order those alongside it.

Answer by: Customer Support on Sep 7, 2025, 11:24 AM

Would this sleeve hold up if it was right next to the engine block?

Question by: Curt W on Jul 11, 2025, 12:58 PM

Designed to protect hoses from direct flame, this fire sleeve is made from braided fiberglass tubing and flame-resistant silicone rubber. Its construction is well-suited for environments with high heat exposure.

Answer by: Customer Support on Jul 13, 2025, 9:09 AM

what size hose is this sleeve actually built for? trying to figure out if a 2 3/8 inch hose fits inside it right

Question by: Ross B on May 30, 2025, 1:27 PM

The sleeve carries a 2.38 inch inner diameter, so a hose measuring right around 2 3/8 inches across will fit inside it. That's the bore size you're working with when sizing it up against your assembly.

Answer by: Customer Support on Jun 1, 2025, 9:11 AM

What size clamp do I need to hold this fire sleeve in place?

Question by: Wayne K on Dec 15, 2025, 3:07 PM

You'll need two of the FF9217-0648S clamps for each hose assembly.

Answer by: Customer Support on Dec 17, 2025, 6:00 AM

Similar Products

Model Number	Accessories	I.D.
624-24	Clamp (2 Required Per Hose Assembly): FF9217-0648S	1.5 in
624-38	Clamp (2 Required Per Hose Assembly): FF9217-0648S	2.38 in
624-46	Clamp (2 Required Per Hose Assembly): FF9217-0664S	2.88 in
624-13	Clamp (2 Required Per Hose Assembly): FF9217-0622S	0.81 in
624-14	Clamp (2 Required Per Hose Assembly): FF9217-0622S	0.88 in