Rubber, Wire-braid Hydraulic Hose Assembly, 0.25 Inch ID Hose, 6 ft Foot Length, 3/8 NPTF Fittings, Plastic Guard, Up To 10000.00 PSI

10,000 psi is the maximum operating pressure, not burst. Burst pressure on this assembly is rated at 20,000 psi, so there's a 2:1 safety margin built in. The hose itself is reinforced with two braids of high tensile steel wire, which is what gets it to that operating pressure rating. For most high-force hydraulic tool applications, that 10,000 psi working pressure is right in line with what the system demands.

This hose is rated for an operating pressure of up to 10,000 PSI. It's made with a wire-braid reinforcement and a rubber covering for oil and weather resistance. Whether it's suitable for your specific press depends on the pressure and operating conditions.

With 3/8 NPTF fittings on both ends, it’s set up for connections that are also 3/8 NPTF. If your ports are 3/8 NPTF male and you need a female hose end, that’s the match this assembly is built around.

It matches a 0.25 inch I.D. hose assembly and it has 3/8 NPTF fittings on both ends, so it lines up with that common size and thread style.

This hose is made with a rubber covering that resists both oil and weather, and it's reinforced with two braids of high-tensile steel wire. It's designed for an operating pressure of up to 10,000 psi.

Comes fully assembled with 3/8 NPTF fittings already attached on both ends, plus a coupler and dust cap included. Nothing extra to buy or press on before putting it to work.