H Series Geroter Motor, 2.80 cu in/rev, 2 Bolt Mounting Flange, 1 in. Straight Keyed Shaft, 7/8-14 St.Thd O-Ring Ports, Compact yet powerful|Extended bearing life|Increased shaft seal

For a 2-bolt flange and a 1-inch straight keyed shaft, this motor fits right into a lot of standard auger configurations. The port size is 7/8-14 straight thread O-ring, so as long as your existing fittings match up on all three points, you're looking at a clean replacement. The 2.80 cu in/rev displacement is worth confirming against your original motor spec too, since that affects your speed and torque output at a given flow rate.

It matches a 2 bolt mounting flange and a 1 in. straight keyed shaft, so it lines up with setups that call for that mount and shaft style.

Designed for agricultural equipment like harvesters, this geroter motor should perform well under continuous use, assuming you stay within the recommended operating temperature of 180°F and case pressure of 1500 PSI.