H Series Geroter Motor, 14.10 cu in/rev, 4 Bolt Mounting Flange, 1 in. Straight Keyed Shaft, 7/8-14 St.Thd O-Ring Ports, Compact yet powerful|Extended bearing life|Increased shaft seal

For agricultural auger applications, 14.1 cu in/rev is well within the intended use range for this motor. It's rated at 302 Newton meters of torque, which translates to solid pulling power for auger and harvester work. That said, before you put it under full load, Eaton Char-Lynn recommends running it for roughly an hour at about 30 percent of rated pressure to break it in properly. Skipping that step tends to shorten motor life, especially on heavy-duty harvest equipment. Make sure the motor is fully primed with fluid before any load goes on it.

This H series geroter motor is listed as being suitable for agricultural augers and seeders, so it should do the job. Just make sure the specs line up with your equipment.

This motor is set up with a 4 bolt mounting flange and .875-14 UNF-2B SAE O-ring ports, which is the same as 7/8-14 straight thread O-ring ports.