H Series Geroter Motor, 2.80 cu in/rev, 4 Bolt Mounting Flange, 1 in. Straight Keyed Shaft, 7/8-14 St.Thd O-Ring Ports, Compact yet powerful|Extended bearing life|Increased shaft seal

It matches a 4 bolt mounting flange and it comes with a 1 in. straight keyed shaft. The ports are 7/8-14 straight thread SAE O-ring (UNF-2B), so your hoses and fittings need to match that style too.

This Char-Lynn H Series motor is a good fit for agricultural equipment such as augers, harvesters, and seeders. It's also used in industrial machinery like sweepers and floor polishers.

Run it for about an hour at roughly 30% of its rated pressure before you put it under full load. Also make sure the motor is filled with fluid before you apply any load at all. Skipping that step is where a lot of premature wear comes from, so it's worth taking the time upfront.