H Series Geroter Motor, 14.10 cu in/rev, 4 Bolt Mounting Flange, 1 in. Straight Keyed Shaft, 1/2 NPT Ports, Compact yet powerful|Extended bearing life|Increased shaft seal

Porting is .500-14 NPTF Dryseal pipe thread, with 1/2 NPT ports called out for the motor.

Running the motor for about an hour at 30 percent of its rated pressure is the right way to break it in. Make absolutely sure the unit is filled with premium anti-wear hydraulic fluid prior to applying any load to protect the bearings.

Keep operating temps at or below 180 degrees F and you'll be in good shape. Push past that consistently and you're looking at accelerated wear on seals and internals. The shaft seal on this unit is built for durability, but staying within that thermal limit is what keeps it that way long term.

This motor is typically found on agricultural augers, harvesters, seeders, and even industrial sweepers and floor polishers.

For a compact setup, this H Series geroter motor is a 14.10 cu in/rev unit with a 4 bolt mounting flange. It uses 1/2 NPT ports with .500-14 NPTF Dryseal pipe threads, and the output is a 1 inch straight keyed shaft.