Four Heavy Spiral Wire SAE 100R12 Hose, 2.00 Inch ID, Up to 4000.00 PSI

Four thousand PSI is exactly what this hose is rated for at maximum operating pressure. The four-spiral wire reinforcement is what gets it there. That construction handles high-pressure hydraulic loads better than braided alternatives in the same size range, so for a 2-inch ID line running at or near that pressure ceiling, you are in the right territory.

This hose is designed for hydraulic systems using either petroleum-based or water-based fluids.

Bend radius is the main limit to watch on this one. The minimum bend radius is 25.2 inches, so you want your routing to stay at or above that to help avoid kinking and premature hose damage.

Four-spiral wire construction at 2-inch ID is built for exactly that kind of sustained high-pressure work. The 4000 PSI rating on the GH493-32 is the maximum operating pressure, so running it at or near that figure on a press circuit is well within its intended use. The million-cycle impulse rating backs that up too. Long service intervals under repetitive load are something this series handles without issue.