FTNG (PERM), ORS FJ3255-0404S

Specifications

Drop Dimension 0.84	Brand Danfoss Power Solutions (II LLC Aeroquip)	Brand Aeroquip	Pack Size 1.00	UOM EA	End Gender 1 13553	End Size 1 0.56	End Type 1 ORS	End Type 2 Line/Hose/Tube	Features Dura-Kote plating for superior corrosion resistance\|Innovative design to deliver performance and maximum uptime\|System engineered to extend hose assembly life	Hose Dash Size -4	ICC Hose Fittings	Item Type Fitting Assembly	Language English	Net Pack Quantity Units EA	Product Material Carbon Steel	Product Width 0.69	Sub Brand Aeroquip	Supplier Part Number FJ3255-0404S	Product Weight 0.50 lbs

Product Questions & Answers 3

Product Questions & Answers

fitting's got Dura-Kote on it, how well does that actually hold up against rust and corrosion out in the field?

Question by: Brenda K on Oct 11, 2025, 8:37 AM

Carbon steel fittings without a protective coating won't last long in wet or chemically active environments, but the Dura-Kote plating on this one is specifically there to push back against corrosion in demanding service conditions. It's not just a cosmetic finish. Eaton Aeroquip engineered it as part of a longer-service-life system, so the plating is meant to contribute to keeping the full hose assembly running longer between replacements. For general hydraulic field use where moisture and grime are a regular factor, it holds up well.

Answer by: Customer Support on Oct 13, 2025, 7:15 AM

Is this fitting made to last a while in a hydraulic setup that sees some weather?

Question by: Cheryl F on May 27, 2025, 7:43 PM

Dura-Kote plating on this Eaton Aeroquip fitting provides enhanced corrosion resistance, which should help it hold up well in demanding environments.

Answer by: Customer Support on May 29, 2025, 6:52 AM

trying to swap out a 90 degree ORS end on a -4 hose, is this the right one with the 9/16 thread?

Question by: Neal B on Sep 15, 2025, 12:58 PM

Match up three things: it is a permanent crimp fitting for a -4 dash hose, it is a 90 degree elbow, and the swivel ORS end uses a 9/16-inch thread. If those are what you are replacing, this one lines up.

Answer by: Customer Support on Sep 17, 2025, 6:40 AM