Skip to the beginning of the images gallery

AQP Wire Inserted Suction SAE 100R4 Blue Hose, 1.25 Inch ID, Up To 200.00 PSI

Abrasion Resistance 29	Application Suction application for hydraulic, lubrication oils, gasoline, air, water and chemical transfer.	Color Blue	Conductivity 30	Construction 2-ply braid	Cover Material Elastomer	Dash Size -20	Brand Danfoss Power Solutions (II LLC Aeroquip)	Brand Aeroquip	Pack Size 12.00	UOM FT	Hose I.D. 1.25	Hose O.D. 1.80	Impulse Cycle Life 500000 cycle	Lay Line Style Embossed	Maximum Operating Pressure 200	Minimum Bend Radius 8	Minimum Bend Radius 8	Minimum Working Temperature -40	Reel Qty (ft) Rolls Only	Reinforcement Material Helical Wire and Textile	Supplier Part Number 2661-20	Tube Material Synthetic Rubber	Vacuum Service 28	Alternate Part Numbers Alternate Part Number C1BJ22	Product Weight 2.06 lbs

Product Questions & Answers 4

Product Questions & Answers

trying to run hot phosphate ester fluid through my setup. what kind of heat can the hose handle before the rubber starts breaking down

Question by: Wes W on Nov 2, 2025, 5:17 PM

Operating temperatures for the AQP elastomer material safely range from negative 40 up to 300 degrees Fahrenheit. The synthetic rubber tube and blue cover are fully rated to transfer petroleum and phosphate ester hydraulic fluids without degrading under those extreme conditions.

Answer by: Customer Support on Nov 4, 2025, 6:16 AM

got a suction line that needs 1-1/4 inch ID, is this the one and what size is it on the outside

Question by: Dwayne H on Jul 14, 2025, 3:08 PM

For fit and routing, the inside diameter is 1.25 inch and the outside diameter is 1.8 inch. The minimum bend radius is 8 inches, so it needs a fairly gentle sweep when you lay it in.

Answer by: Customer Support on Jul 16, 2025, 6:18 AM

got a tight spot to snake this through. how sharp can i bend that 1-1/4 suction hose without kinkin it up

Question by: Lyle D on Oct 15, 2025, 6:19 AM

For routing, the minimum bend radius is 8 inches. Keeping your bend at or above that helps it stay flexible without collapsing or kinking, which matters on suction lines.

Answer by: Customer Support on Oct 17, 2025, 6:47 AM

What kind of fittings work with this hose? Just wanna make sure I get the right ones.

Question by: Eddie W on Jan 13, 2026, 5:38 PM

Global TTC fittings and shank type combination nipples are compatible, so you're good to go with those. Use T-Bolt or preformed clamps for installation.

Answer by: Customer Support on Jan 15, 2026, 6:55 AM

Similar Products

Model Number	Hose I.D.	Hose O.D.	Maximum Operating Pressure	Minimum Bend Radius	Vacuum Service	Reel Qty (ft)
2661-20	1.25	1.8	200	8	28	Rolls Only
2661-16	1	1.5	250	6	28	Rolls Only
2661-24	1.5	2.06	150	10	28	Rolls Only
2661-32	2	2.55	100	12	28	Rolls Only
2661-12	0.75	1.25	300	5	28	Rolls Only