Designed for system stack mounting, the DGMX2-3 40 valve should integrate easily into existing setups. It helps reduce installation costs.
Answer by: Customer Support on Apr 6, 2025, 8:37 PM
flow rate on this one, is 60 LPM enough for most machine tool setups, or is that on the low end?
Question by: Todd B on Nov 9, 2025, 7:22 PM
For a wide range of machine tool applications, 60 liters per minute is a solid working flow rate. SystemStak valves like this one are built around stacked configurations, so you can manage flow across multiple circuits without pushing any single valve beyond its limits. Most standard machine tool cycles run well within that range, so unless you're running something with unusually high simultaneous demand, this fits the bill.
Answer by: Customer Support on Nov 11, 2025, 1:06 PM
