Got a spot on a manifold that's tight on clearance, would a 90-degree MJIC-to-ORB fitting help route the line without kinking it?
Question by: Chad R on Apr 24, 2025, 11:02 AM
Tight quarters are exactly where a 90-degree configuration earns its keep. Instead of forcing a hose to bend sharply after a straight fitting, the 90-degree angle does the turning right at the connection point, keeping the line straighter and the bend radius more manageable. This one steps down from a #10 ORB port on the manifold side to a #6 JIC hose end, so just confirm those thread sizes match up with your port and hose before you run with it.
Answer by: Customer Support on Apr 26, 2025, 8:30 AM
Hey, will this fitting hold up okay in a hydraulic system running around 2000 psi?
Question by: Wade R on Nov 29, 2025, 7:01 PM
Crafted from high-quality materials, this fitting is designed to withstand high-pressure environments typical in hydraulic systems, so 2000 psi should be well within its operating capacity.
Answer by: Customer Support on Dec 1, 2025, 5:53 PM
got a tight spot on a hose run, is this the 90 degree adapter that goes from a #6 male JIC over to a #10 male ORB?
Question by: Pete C on Oct 28, 2025, 3:54 PM
In a cramped layout, the 90 degree bend is exactly what helps you turn the line without forcing a big loop. This fitting is built to connect a #6 MJIC (male JIC) end to a #10 MORB (male O-Ring Boss) end at a right angle.
Answer by: Customer Support on Oct 30, 2025, 1:00 PM
