Alternate Part NumberC1KB61, Alternate Part Number KFDG4V52C70NZMU1H720
Application
Die casting & foundry, Machine tool, Marine/Offshore, Press, Primary metal, paper, Test equipment & simulation, Turbine control (wind, steam, water)
Brand
DANFOSS POWER SOLUTIONS II LLC (VICKERS)
Brand
Vickers
Pack Size
1.00
UOM
EA
Features
Available in three performance levels - ultra, high and standard - to suit a wide range of application requirements|Direct-acting|Reduce commissioning time through plug-and-play funcitonality
what all is this valve rated to handle flow-wise, and is 70 LPM enough for a press application?
Question by: Cindy G on Aug 29, 2025, 8:47 AM
Rated at 70 litres per minute, and yes, that puts it well within range for most press setups. Press applications are actually one of the listed use cases for this valve, alongside die casting, machine tool work, and turbine control, so it's not a stretch to say it was built with that kind of demand in mind. Being direct-acting also means response is more immediate compared to pilot-operated designs, which tends to matter in press cycles where timing is everything.
Answer by: Customer Support on Aug 31, 2025, 6:59 AM
Can this valve handle dirty fluids or does it need a filter?
Question by: Hugh M on Feb 28, 2026, 8:13 AM
Designed for applications like die casting and machine tools, this valve should operate reliably with typical hydraulic fluids, but keeping your system clean will always help extend its life.
Answer by: Customer Support on Mar 2, 2026, 6:54 AM
