Metric Banjo Bolt M10X1.50

At 24mm overall length with an M10 x 1.5 thread pitch, there's enough length to seat properly through a standard banjo fitting eye and engage the port threads on most hydraulic motors and similar components. The L2 dimension comes in at 19mm, which reflects the usable thread and body length below the head. For tight port installations that's a pretty common size range, and this bolt is built to work with standard banjo fittings and sealing washers at that thread pitch. Just make sure you're pairing it with the correct crush washers on both sides of the banjo eye for a proper seal.

With an M10 x 1.5 metric male thread, it matches standard banjo fittings and sealing washers that use that same M10 x 1.5 pitch.

This Adaptall banjo bolt is designed to fit any standard banjo fitting and sealing washer sized for an M10 x 1.5 thread pitch.