Skip to the beginning of the images gallery

VICKERS-DGMC 3 PT CW 41 EN411

Application Die casting & foundry, Machine tool, Marine/Offshore, Press, Primary metal, paper, Test equipment & simulation, Turbine control (wind, steam, water)	Brand Danfoss (Power Solutions II LLC)	Brand Vickers	Pack Size 1.00	UOM EA	Features Reduce installation costs\|Eliminate external leakage\|Boost resistance to contamination	Flow Rate1 60 litre per minute	ICC IV Directional Control Valves	Language English	Product Width 1.87	Seal Material Buna-N	Special Features None	Sub Brand Vickers	Supplier Part Number 02-360980	Product Weight 2.90 lbs

Product Questions & Answers 2

Product Questions & Answers

I'm trying to replace a valve in an older machine. Is this one likely to fit where a DGMC 3 PT CW 41 used to be?

Question by: Keith H on Jun 15, 2025, 6:04 PM

This Vickers DGMC 3 PT CW 41 EN411 valve is part of the Design SystemStak Valves series, so it should be a direct replacement if your original valve is from the same series.

Answer by: Customer Support on Jun 17, 2025, 4:52 PM

flow rate on this one is listed at 60 LPM, that enough for press and die casting work or is it gonna be a bottleneck?

Question by: Roger R on Jan 24, 2026, 2:54 PM

For most press and die casting setups, 60 liters per minute is a reasonable working capacity. Those applications are exactly what this valve was built around, so you're not trying to fit a square peg in a round hole. Just make sure your system demand at peak load stays within that rated flow to avoid pressure drop issues.

Answer by: Customer Support on Jan 26, 2026, 12:13 PM