VICKERS DG4V32NMUEK660 02-358125

Specifications

Application Die casting & foundry, Machine tool, Marine/Offshore, Press, Primary metal, paper, Test equipment & simulation, Turbine control (wind, steam, water)	Brand Danfoss (Power Solutions II LLC)	Brand Vickers	Pack Size 1.00	UOM EA	Features Three- or four-way directional control\|Easily mountable on industry-standard surfaces\|Thousands of models to suit all applications	Flow Rate1 80 litre per minute	ICC IV Directional Control Valves	Language English	Net Pack Quantity Units EA	Product Width 1.80	Seal Material Buna-N	Special Features None	Sub Brand Vickers	Supplier Part Number 02-358125	Product Weight 4.00 lbs

Product Questions & Answers 2

Product Questions & Answers

Can this Vickers valve handle the pressures in a typical die casting setup, or do I need something beefier?

Question by: Dale M on May 11, 2025, 8:26 AM

Built for demanding industrial uses, this Vickers DG4V32NMUEK660 directional control valve is well-suited for die casting and foundry applications. Its Buna-N seal material helps ensure leak resistance, even in high-pressure scenarios.

Answer by: Customer Support on May 13, 2025, 7:22 AM

flow rate on this one is 80 liters per minute, that right? trying to figure out if it'll keep up with our press line without bottlenecking the system

Question by: Roger T on Nov 1, 2025, 6:38 PM

80 liters per minute is correct for this valve. For press applications specifically, that flow capacity puts it well within the range of what most mid-scale press systems pull during active cycles. It's also listed as a fit for press and machine tool environments, so your use case lines up with what this valve was built to handle.

Answer by: Customer Support on Nov 3, 2025, 6:12 AM