VICKERS DGMFN-5P-X-P2W-30 02-355579

Specifications

Application Die casting & foundry, Machine tool, Marine/Offshore, Press, Primary metal, paper, Test equipment & simulation, Turbine control (wind, steam, water)	Brand Danfoss (Power Solutions II LLC)	Brand Vickers	Pack Size 1.00	UOM EA	Features Reduce installation costs\|Eliminate external leakage\|Boost resistance to contamination	Flow Rate1 120 litre per minute	ICC IV Directional Control Valves	Language English	Product Width 2.82	Seal Material Nitrile	Special Features None	Sub Brand Vickers	Supplier Part Number 02-355579	Product Weight 7.00 lbs

Product Questions & Answers 2

Product Questions & Answers

If I'm swapping out an old SystemStak valve, will this one just drop right in, assuming it's also a size 5?

Question by: Howard M on May 12, 2025, 9:53 PM

Designed for modularity, the DGMFN-5P-X-P2W-30 is built to fit standard SystemStak base plates and manifold assemblies of the same size-5 frame. At 2.82 inches wide, it should be a direct replacement, assuming the existing valve follows the same SystemStak standard.

Answer by: Customer Support on May 14, 2025, 11:57 AM

Does the modular stacking setup on this valve actually cut down on how much hydraulic connections you gotta run between stations?

Question by: Pete E on Dec 27, 2025, 7:48 PM

Pretty much, yeah. The SystemStak architecture lets multiple valve stations share a common body without external connecting lines between them. That means fewer fittings, less tubing, and fewer potential leak points in the circuit. For anyone putting together a machine tool or press system with multiple control stages, that reduction in hydraulic connections can add up to real time and cost savings during installation.

Answer by: Customer Support on Dec 29, 2025, 9:21 AM