been trying to track down a replacement for our old DG4V-3 series valve on one of our press lines -- does this part swap in without having to modify the subplate or manifold setup we already got?
Question by: Harvey W on Jul 23, 2025, 7:49 PM
Spring-centered, two-solenoid valves on the DG4V-3 platform are built around a standardized subplate mounting arrangement, so if your existing manifold was set up for this series, you should be looking at a direct drop-in situation. The DG4V 3S 2A M U G5 carries alternate part numbers including DG4V3S2AMUG560EN21 and C1JU88, which can help you cross-reference against your current valve to confirm it's the same unit before committing to the order.
Answer by: Customer Support on Jul 24, 2025, 8:09 PM
Wondering if this Vickers valve would be a suitable replacement for a DG4V-3 series valve in a hydraulic press I'm working on?
Question by: Brenda P on Nov 1, 2025, 10:32 AM
Given that this is a DG4V-3 platform valve, it should integrate into your hydraulic press system, assuming your current setup uses standard hydraulic manifold and subplate mounting. It's built for reliable, repeatable switching, so it's a good fit for the kind of consistent response you need in a press application.
Answer by: Customer Support on Nov 3, 2025, 6:18 AM
