VICKERS KCG 8 W250 1 Z M U 02-155969

Specifications

Alternate Part Numbers Alternate Part Number KCG8W2501ZMUH110	Application Die casting & foundry, Machine tool, Marine/Offshore, Press, Primary metal, paper, Test equipment & simulation, Turbine control (wind, steam, water)	Brand Danfoss (Power Solutions II LLC)	Brand Vickers	Pack Size 1.00	UOM EA	Features Available in three performance levels - ultra, high and standard - to suit a wide range of application requirements\|Direct-acting\|Reduce commissioning time through plug-and-play funcitonality	Flow Rate1 400 litre per minute	ICC IV Proportional Valves	Language English	Net Pack Quantity Units EA	Product Width 4.20	Seal Material Buna-N	Special Features None	Sub Brand Vickers	Supplier Part Number 02-155969	Product Weight 12.80 lbs

Product Questions & Answers 2

Product Questions & Answers

For die casting use, is this the best Vickers valve option or are there others I should look at?

Question by: Randy P on Jun 24, 2025, 8:51 AM

Selection depends on the specific demands of your die casting operation. This Vickers valve is well-suited for die casting applications due to its robust design and efficient hydraulic flow management at 400 liters per minute, but reviewing all available Vickers options and their respective specifications is recommended to make sure all requirements are met.

Answer by: Customer Support on Jun 25, 2025, 10:22 AM

flow rate on this one says 400 liters per minute -- that enough for press or turbine control applications or is it pushing the limits?

Question by: Floyd T on Jan 24, 2026, 5:53 PM

For press and turbine control work, 400 liters per minute is a solid number. Vickers sized this valve to handle those kinds of demanding cycles, and turbine control along with press applications are both listed as intended uses. Whether it's wind, steam, or water turbine setups, or a hydraulic press line, the flow capacity holds up for those environments without being pushed to its edge.

Answer by: Customer Support on Jan 26, 2026, 7:11 AM