KDG4V333C13NHMUHA760 02-147654

Specifications

Application Die casting & foundry, Machine tool, Marine/Offshore, Press, Primary metal, paper, Test equipment & simulation, Turbine control (wind, steam, water)	Brand Danfoss (Power Solutions II LLC)	Brand Danfoss Power Solutions	Pack Size 1.00	UOM EA	Features Available in three performance levels - ultra, high and standard - to suit a wide range of application requirements\|Direct-acting\|Reduce commissioning time through plug-and-play funcitonality	Flow Rate1 13 litre per minute	ICC IV Proportional Valves	Language English	Product Width 1.90	Seal Material Fluorocarbon	Special Features None	Sub Brand Vickers	Supplier Part Number 02-147654	Product Weight 5.30 lbs

Product Questions & Answers 2

Product Questions & Answers

flow rate on this one is 13 liters per minute, is that gonna hold up alright for machine tool work or is it too low for most setups?

Question by: Rex P on Jun 21, 2025, 6:22 PM

For machine tool applications, 13 liters per minute is well within the typical operating range for proportional valve control work. This valve was built with machine tools as one of its primary use cases, so that flow rate isn't an arbitrary number. It's matched to the kind of precise, controlled flow demand that machine tool circuits usually call for. If your system is already sized around similar flow requirements, it should fit right in without any need to compensate elsewhere in the circuit.

Answer by: Customer Support on Jun 23, 2025, 7:42 AM

reckon this valve could handle the kinda pressures you get in a die casting setup?

Question by: Randy T on May 13, 2025, 3:01 PM

Built by Vickers under Danfoss Power Solutions, this proportional valve is well-suited for demanding industrial applications, including die casting and foundry work.

Answer by: Customer Support on May 15, 2025, 2:41 PM