VICKERS DGMC 3 AB GW 41 02-147185

Specifications

Application Die casting & foundry, Machine tool, Marine/Offshore, Press, Primary metal, paper, Test equipment & simulation, Turbine control (wind, steam, water)	Brand Danfoss (Power Solutions II LLC)	Brand Vickers	Pack Size 1.00	UOM EA	Features Reduce installation costs\|Eliminate external leakage\|Boost resistance to contamination	Flow Rate1 60 litre per minute	ICC IV Directional Control Valves	Language English	Net Pack Quantity Units EA	Product Width 1.87	Seal Material Buna-N	Special Features None	Sub Brand Vickers	Supplier Part Number 02-147185	Product Weight 2.90 lbs

Product Questions & Answers 3

Product Questions & Answers

got a systemstak setup already. is this DGMC-3 41 design valve meant to help cut down on leak points or am i thinking of something else

Question by: Brett W on Aug 17, 2025, 12:04 PM

In a SystemStak stack, the DGMC-3 41 design valve is used to reduce installation costs and eliminate external leakage by keeping the function in the stack instead of relying on extra external hydraulic connections.

Answer by: Customer Support on Aug 18, 2025, 4:49 PM

flow rate on this valve, is 60 liters per minute the max it'll handle or just the rated continuous flow?

Question by: Harvey W on Aug 13, 2025, 3:32 PM

Sixty liters per minute is the rated flow for this valve. Running right at the rated flow continuously puts you at the edge of the design envelope, so most folks size their system to stay a bit below that ceiling during normal operation. If your application regularly pushes against that number, it's worth accounting for pressure drop and heat buildup in your circuit design.

Answer by: Customer Support on Aug 15, 2025, 6:01 AM

Would this stack valve be a good fit for a die casting machine?

Question by: Dwayne F on Dec 11, 2025, 5:51 PM

Yes, this Vickers DGMC-3 valve is suitable for die casting and foundry applications, according to the listed applications.

Answer by: Customer Support on Dec 13, 2025, 12:16 PM