Vickers KDG4V 3 33C20N Z M 02-146721

Specifications

Alternate Part Numbers Alternate Part Number KDG4V333C20NZMUH760	Application Die casting & foundry, Machine tool, Marine/Offshore, Press, Primary metal, paper, Test equipment & simulation, Turbine control (wind, steam, water)	Brand Danfoss (Power Solutions II LLC)	Brand Vickers	Pack Size 1.00	UOM EA	Features Available in three performance levels - ultra, high and standard - to suit a wide range of application requirements\|Direct-acting\|Reduce commissioning time through plug-and-play funcitonality	Flow Rate1 20 litre per minute	ICC IV Proportional Valves	Language English	Net Pack Quantity Units EA	Product Width 1.90	Seal Material Fluorocarbon	Special Features None	Sub Brand Vickers	Supplier Part Number 02-146721	Product Weight 5.30 lbs

Product Questions & Answers 3

Product Questions & Answers

flow rate on this unit is listed at 20 liters per minute -- is that enough for press applications or would it be on the low end?

Question by: Curt B on Feb 10, 2026, 5:46 PM

For press applications, 20 liters per minute sits on the moderate end of the range. The KDG4V-3 is explicitly listed for press use, so the flow capacity aligns with what that application calls for in many setups. Whether it covers your specific press depends on the demand of your circuit, but the valve is matched to that environment by design.

Answer by: Customer Support on Feb 12, 2026, 5:26 PM

got a machine tool setup that needs a proportional valve, is this one in that wheelhouse?

Question by: Glen P on Nov 8, 2025, 2:05 PM

For machine tool work, this valve fits right in since machine tool is one of the listed application areas, along with press and test equipment and simulation.

Answer by: Customer Support on Nov 10, 2025, 7:07 AM

I'm seeing this valve is for "die casting". Can I use it for somethin' else, like runnin' a log splitter?

Question by: Hugh D on Dec 27, 2025, 9:43 PM

Application-wise, it's suitable for a range of uses, including machine tools, marine/offshore setups, presses, metal work, paper mills, simulation equipment, and turbine control systems, in addition to die casting.

Answer by: Customer Support on Dec 29, 2025, 1:54 PM